Frequently Asked Questions

A: VICI Metronics Inc. Condyne Div., FC30AS4K with stainless steel fittings 6-0016-0

The wetted parts are : Aluminum, Stainless Steel, Viton O-Rings, and a Nylon washer​

A: 10 microns​

A: Less than or equal to 0.4 standard liter per minute (SLPM).​

A: 



A: We can supply adapters that will change the inch tubing to (mm). This will increase the length of the instrument by 1.25".

A: Here are the pertinent specifications about the flow controller and flow switch direct from the manufacturer. ​

A: The 125 series has material options of 316 stainless steel, brass or Teflon. This would be indicated by the part number. The Chem-Tec part number is 125-316-NO. The wetted material in this unit is 316 stainless steel, epoxy and viton. 

A: The hysteresis is 30% above the set point. ​

A: TAI part number F1263 is King's PN 7520-3301C0-0TE. Wetted parts are: cast acrylic, 316SS, Sapphire float, and PVC float stops.

TAI part number F1902 is King's PN 7530-3322C0-0TE. Wetted parts are: cast acrylic, 316SS, Titanium float, and Viton seals. ​

A: The maximum inlet pressure is 50 psi.

The wetted parts are stainless steel and a EPDM seal. ​

A: TAI PN = V871

Manufacturer: Numatics, part number LS2-0089​

A: V948 ​

A: You can power up the valve boxes without gas being applied. You may get a warning or two, such as flow fault because of this, but the valve box keeps running. 

As to Profibus addresses, just make sure to start with 2 as address 1 is reserved for the master, and do not repeat the address number. ​

A: 9.6 - 187.5 KB/s - 1,000 meters (3,280 feet)

500 KB/s - 400 meters (1,310 feet)

1.5 MB/s - 200 meters (656 feet)​​

3 - 12 MB/s - 100 meters (328 feet)​